Lenze 9400 User Manual download pdf (Page 378)

11 Basic drive functions

11.1 General information

378

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

11.1.4 Priorities

The function states are assigned to priorities so that, if several basic functions are activated at the

same time, it is always changed to the function state with the highest priority:

Priority Function state Executable basic function

1 Initialisation -

2Fault -

3 Controller is not ready -

4Quick stop active Quick stop

( 388)

5 Manual jog active Manual jog

( 395)

6Homing active Homing

( 416)

7 Positioning active Positioning ( 474)

8 Setpoint follower (position) active Position follower

( 485)

9 Setpoint follower (speed) active Speed follower

( 492)

10 Setpoint follower (torque) active Torque follower ( 497)

10 Brake check Brake control

( 517)

12 Drive is stopped Stop

( 384)

13 Manual jog, encoderless active Manual job, encoderless

( 407)

14 Pole position identification active Pole position identification

( 570)

1 ≡ highest priority; 14≡ lowest priority

 Note!

The basic state "Drive at standstill" is automatically adopted if no other state is active.

1 2 ... 373 374 375 376 377 378 379 380 381 382 383 ... 953 954

Comments to this Manuals

No comments