Lenze EtherCAT Controller-based Automation User Manual download pdf (Page 48)

7 Commissioning of the system

7.3 Detailed description of the commissioning steps

Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

C. Store the parameters of the Servo-Inverter i700 in a non-volatile memory so that they are

retained in the device when the power is switched off:

In the boot project of the Lenze Controller, there is a separate parameter set for the lower-level

Servo-Inverters i700. The latter is then only updated when the "boot project" function is

executed via the »PLC Designer«. The current parameterisation is then saved and is available

after mains switching. During boot-up after mains connection, the saved parameter set is

automatically written from the controller into the servo inverter.

[7-2] Parameter set transfer from the 3231 C controller to the Servo-Inverter i700 during a boot-up

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 204 205

No comments

Lenze EtherCAT Controller-based Automation User Manual Page 48