Lenze HMI for visualisation / with control technology User Manual download pdf (Page 40)

Commissioning

Establish Ethernet connection

Activate communication between EL 1xx and VisiWinNet

Smart

 40

LDCDS−EL100 EN 9.0

7.3.2 Activate communication between EL 1xx and VisiWinNet

Smart

The following settings are required if you wish to transmit a VisiWinNET

Smart project to

the EL 1xx via Ethernet. They are not required to establish a general TCP/IP connection.

How to proceed:

 Note!

If an autostart of the Remote Access Manager is specified in the VisiWinNET

Control Panel Applet ( 49), the VisiWinNET Remote Access dialogue is

displayed automatically after starting the HMI.

Proceed as follows if that dialogue is not displayed:

ƒ Start ® Programs ® Windows Explorer

ƒ Folder Flashdisk/VisiWinNET

ƒ Double−click the VisiWinNET.RemoteAccessManager Application.

1. Activate the Commandhandler Registry in the VisiWinNET Remote Access Dialogue.

EL100−020

2. If the TCP/IP control field is selected and the status is displayed as Running,

communication has been enabled. Elsewise, proceed as follows:

3. Select the TCP/IP control field.

4. Click Start.

The status changes to Running. TCP/IP communication has been enabled.

5. Click Save to store this setting.

 See VisiWinNET

Smart software manual, Getting Started, for further

information on project transmission.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 95 96

No comments

Lenze HMI for visualisation / with control technology User Manual Page 40