Lenze 8400 HighLine User Manual download pdf (Page 43)

Lenze · 8400 HighLine · Referenzhandbuch · DMS 10.0 EN · 06/2014 · TD05/TD14 43

2 Introduction: Parameterising the controller

2.4 Device access protection

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Activate the password protection

The password protection is activated by setting a password.

 How to set a password:

1. Enter the desired password in C00505/3

• The password must have a length of 4 ... 16 characters.

• The password may consist of any character. However, this is not sensible.

Recommended characters are: lower case letters (a - z), upper case letters (A - Z) and

digits (0 - 9).

2. Execute "Set password" device command: C00002/31

="1:On / start"

• After successful execution, password status ON is displayed in C00505/3

and password

protection takes immediate effect.

Temporarily deactivate the password protection

The "Check password" device command serves to temporarily deactivate the password protection

in order to execute password-protected functions.

• The password protection remains deactivated until

• an invalid password will be entered and checked

- or -

• the external 24-V supply of the control electronics is switched off (< 19 V).

 How to temporarily deactivate the active password protection:

1. Enter the set password in C00505/3

2. Execute "Check password" device command C00002/32

= "1: On / start"

• After a successful check, password status OK is displayed in C00505/3

Status displays

C00003 Status of the last device command -

C00507/1 Password protection - all communication channels

• Bit coded display of the active protective functions:

Bit 0 Only access to user menu

Bit 1 Parameter write protection

Bit 2 Parameter read protection

Bit 3 ... 14 Reserved

Bit 15 Memory module binding on

Note:

As the password protection can be configured individually for each

single communication channel from version 15.00.00 bit 1 and bit 2

indicate the active protection always with regard to the

communication channel used

Parameter Info Lenze setting

Highlighted in grey = display parameter

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 156 157

Comments to this Manuals

No comments

Lenze 8400 HighLine User Manual Page 43

Comments to this Manuals

Related products and manuals for Software Lenze 8400 HighLine