Change/Save parameters
MA9371BB 2.0 -5-
Change parameters
1. Change from the menus to the code level using the arrow keys z, y, Y or Z .
”Code” is displayed.
2. Select output AIN2/OUT (selection number 55) using
z or y select code or
subcode.
3. Change to the parameter level using PRG.”Para” is displayed.
4. Select output AIN2/OUT (selection number 55) using
Y or Z move the cursor
(small, black bar) under the number to be changed.
5. Select output AIN2/OUT (selection number 55) using
z or y change number.
6. Repeat 4. and 5. to change other numbers, if ncessary.
7. Accept parameters. The way of accepting the changed parameterr is displayed in
frontoftheparameter:
Display in front of the parameter Controller uses the new value
p immediately, during the change
SH+PRG p after pressing T+V.
Acknowledgement: ok in the display
SH+PRG Press S to inhibit the controller.
Press
T+V.
Acknowledgement: ok in the display
Press
U to enable the controller.
8. Press V twicetogotothecodelevel.”Code” is displayed.
You can establish a user menu with max. 32 codes which you use
frequently under C0517.
• The number before the comma is the code number.
• The number after the comma is the subcode.
• Code-subcode combinations are allowed only once.
Save parameter set
You have to save the modified parameters if you do not want to loose them after mains
disconnection.
• You can establish up to four parameter sets, e.g. if you process different materials
on a machine or if this is required by different operating states (setup mode,
”stand-by”).
• If you need only one parameter set, save the modifications permanently under
parameter set 1, since the controller automatically loads parameter set 1 after
mains connection.
How to proceed
1. Change from the menus to the code level using the arrow keys.
”Code” is displayed.
2. Select output AIN2/OUT (selection number 55) using
z or y select C0003.
3. Change to the parameter level using PRG.
”Para” is displayed.
4. Set parameter to 1 using
z or y (also possible during operation).
Note: If the parameter set is to be saved under another number, select 2, 3, or 4
instead of 1.
5. Press
T+V.
”OK” is displayed for approx. 1 s.
Now your settings are saved permanently under parameter set 1 (or 2, 3. 4).
Further information on parameter setting can be obtained from the
corresponding Operating Instructions for the controller.
Comments to this Manuals