Lenze HMI Designer Getting Started User Manual download pdf (Page 44)

HMI Designer

EDBHMI-DEEN DE/EN 4.0

QKRKS qê~åëãáí éêçàÉÅí íç íÜÉ âÉóé~Ç

The keypad must be connected to the PC. ( 31)

mêÉé~êÉ âÉóé~Ç bmjJePNM Ñçê íê~åëãáëëáçå

1. Keep the

key at the keypad pressed.

2. Switch on the supply voltage for the keypad.

3. When “H310 service page” is displayed, release the

key.

pí~êí Ç~í~ íê~åëãáëëáçå áå ejf aÉëáÖåÉê

• Select Tools  Transfer project... to open the Downloader dialog box.

1. In the section Communication port select the serial interface of your PC which is connected to

the download cable EPZ-H110.

2. In the section Baud rate select the baud rate (default: 115200 baud).

3. Tick Update operating unit program to transmit the program.

Ó If you want to update the system program of the keypad at the same time, mark Update

operating unit firmware in addition.

4. Click OK to start the data transmission.

• The program is transmitted to the keypad.

• After the transmission, the display of the keypad shows the first page (start page) of the project.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50

No comments

Lenze HMI Designer Getting Started User Manual Page 44