Lenze SCF frequency inverter User Manual download pdf (Page 30)

30 Lenze 13466146 EDBSF01 v24 EN

4 Commissioning

Use the p and q buttons to scroll to the password value (the factory default password is “225”) and

press the Mode button. Once the correct password value is entered, the display will read "P01", which

indicates that the PROGRAM mode has been accessed at the beginning of the parameter menu (P01

is the ﬁrst parameter). This is shown below:

Press Mode to enter password

Use

p and q to scroll to the password value

Parameter menu is accessed at the first

parameter

NOTE

If the display ﬂashes “Er”, the password was incorrect, and the process to enter the

password must be repeated.

Use the p and q buttons to scroll to the desired parameter number. In the example below, Parameter

19 is being displayed, which is the ACCELERATION TIME of the drive:

Use p and q to scroll to the desired

parameter number (the example is

Parameter 19 - ACCELERATION TIME)

Once the desired parameter number is found, press the Mode button to display the present parameter

setting. The upper right-hand decimal point will begin blinking, indicating that the present parameter

setting is being displayed, and that it can be changed by using the p and q buttons.

Press Mode to display present parameter

setting (example setting is 20.0)

Upper right decimal point blinks

Use p and q to change setting (example

setting changed to 30.0)

Press Mode to store new setting

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 67 68

No comments

Lenze SCF frequency inverter User Manual Page 30